Access Lighting NITRO 2 62293 Installation Instructions

CERTIFICATION: cETL DAMP
INSTALLATION INSTRUCTIONS

IMPORTANT

Before assembling your access lighting fixture, please make sure that
you carefully read through these instruction sheets. Consider having
your fixture installed by a qualified licensed electrician.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations
that may occur. It must be understood that common sense, caution and
care, are factors that can't be built into any product. These factors must
be supplied by the person(s) caring for and operating the fixture.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,
Local and National Electrical Codes. These fixtures are intended for
mounting to a standard 4" x 2 1/2"metal octagon outlet box. The box
must be directly supported by the building structure and U.L. Recognized.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the
Circuit Breaker or by removing the fuse at the fuse box. Just turning the
light off at the light switch is not sufficient to prevent electrical shock.
COLLECTION
NITRO 2

WHAT WE PROVIDE

•
Mounting Hardware
•
Crossbar Plate
•
3 x Glass shades
•
3 x 100W J78
1

PREPARE FIXTURE

If there is an existing fixture remove it.
Expose the supply wire from the J-box.
1
APPLICATION MODEL NO.
Wall Fixture

WHAT YOU NEED

•
Screwdriver
•
Wire Cutters
•
Wiring Supplies as Specified
by Electrical Code
NO. 62293
62293