Advertisement
Connect the yellow IDE cable to the hard drive.
Again, be sure the cable is pushed snugly into the
drive. The notch in the cable should face up. Be very
careful not to bend any of the hard drive pins.
7. RE-ATTACH THE TIVO LID
Look at the front of the TiVo with the lid off. You
will notice 9 dimples on a metal strip. In between
those dimples and the front of the TiVo is a small
gap. Now look at the front of the TiVo lid. You will
see a small metal strip along the front of the lid. Hold
the lid at an angle and slide the lid's metal strip
inside the gap in the front of the TiVo.
Once the lid is in place, you can lower it down. Pull
the sides of the lid apart slightly and push the lid
down. Once the lid is in place, screw the four silver
screws into the sides of the TiVo (two on each side).
Then screw in the four screws on the back of the lid
and the four screws into the fan case.
Once all of the screws are in place, you may reconnect your TiVo and power it on. The TiVo will say: "Clearing and Deleting Everything. This will
take an Hour." This process should take about 15 minutes. Once you have gone through the guided setup process, you will be able to verify the
capacity of your unit in the System Information screen.
ENJOY! We thank you very much for your purchase and hope that you enjoy your newly-upgraded TiVo. Please email us with any comments,
suggestions or complaints. If you found the upgrade easy to install (or even if you found it more difficult than you expected), we'd like to
know. If you found our service to be excellent (or awful), we want to know that too. We're always looking to improve our products and
services...the more we hear from you, the better. Thanks very much!
Advertisement
