Power Supply; Basic Operation - Philips AZ1308/37B Owner's Manual

Mp3-cd soundmachine
Hide thumbs Also See for AZ1308/37B:
Table of Contents

Advertisement

English
Supplied Accessories
– AC power cord
Top/front panels
(See 1)
1 Source selector: CD/MP3,TUNER, OFF
– selects CD/MP3, or radio (FM/AM) source
of sound
– power off switch
2 Display – shows the status of the disc/tuner
3 9 – stops CD/MP3 playback;
– erases a CD/MP3 program
4 2 ; – starts or pauses CD/MP3 playback
MODE – selects different play modes:
e.g. REPEAT or SHUFFLE (random order)
PROG
CD/MP3: – programs tracks and reviews the
program
TUNER: – programs preset radio stations
ALB/PRESET +/-
For MP3: – selects albums (up, down)
TUNER: – selects a preset radion station
5 LIFT TO OPEN – opens/ closes the CD
door.
6 DBB (Dynamic Bass Boost)
– turns the bass enhancement on/off.
7 Telescopic antenna - improves FM
reception.
This product complies with the FCC-Rules, Part 15 and with 21 CFR 1040.10. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause unde-
sired operation.
Controls
8 TUNING § ∞
TUNER: – tunes to radio stations
CD/MP3: – selects the next/previous track
– fast searches forwards/backwards
(press and hold the button) with-
in the current track
9 BAND – selects waveband: FM or AM
Back/bottom panels (
See 1)
0 VOLUME – adjusts volume level
! p – 3.5 mm stereo headphone socket
Helpful hints: The speakers will be muted
when headphones are connected to the set.
@ AC MAINS~ – inlet for power cord.
# Battery door – open to insert 6 x 1.5V
R-14/ UM-2/ C-cells
CAUTION
- Visible and invisible laser radiation.
If the cover is open, do not look at
the beam.
- High voltage! Do not open.You run
the risk of getting an electric shock.
The machine does not contain any
user-serviceable parts.
- Modification of the product could
result in hazardous radiation of
EMC or other unsafe operation.

Power Supply

Power Supply
Whenever convenient, use the power supply
cord if you want to conserve battery life.
Make sure you remove the plug from the set
and wall outlet before inserting batteries.
Batteries (not included)
1 Open the battery door and insert 6 batteries,
typed R-14, UM-2 or C-cells, (preferably
alkaline) with the correct polarity as indicated
by the "+" and "–" symbols inside the com-
partment. (See 1)
2 Replace the battery door, making sure the bat-
teries are firmly and correctly in place.The set is
now ready to operate.
Batteries contain chemical substances, so
they should be disposed of properly.
Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to burst:
Do not mix battery types: e.g. alkaline with car-
bon zinc. Only use batteries of the same type
for the set.
When inserting new batteries, do not try to mix
old batteries with the new ones.
Remove the batteries if the set is not to be used
for a long time.
Using AC power
1 Check if the power voltage, as shown on
the type plate located on the
bottom of the set, corresponds to your
local power supply. If it does not, consult your
dealer or service center.
2 Connect the power cord to the
AC MAINS~ inlet and the wall socket.The
set is now connected and ready for use.
3 To switch the set off completely, withdraw the
power cord from the wall socket.
4 Install the unit near the AC outlet and where
the AC power plug can be easily reached.

Basic Operation

Disconnect the power cord from the wall
socket to protect your set during heavy
thunderstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.
The type plate is located on the
bottom of the set.
Helpful hints:
To avoid unnecessary energy consumption,
always adjust the Source selector to OFF
after using the set.
Basic operation
Switching on and off and selecting the
function
1 To select your sound source, adjust the
Source selector to: CD/MP3 or
TUNER.
2 To switch off the set, adjust the
Source selector to OFF position.
Adjusting volume and sound
1 Adjust the volume with the VOLUME 3, 4
controls.
➜ Display briefly shows U U o o L L and the vol-
ume level in number from 00-32.
2 Adjust DBB to select dynamic bass boost on
or off.
➜ Display shows "DBB" when activated.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Az1308/37Az1308

Table of Contents