FFM-TITAN-1500-PRO USER MANUAL CONTENTS BEFORE YOU BEGIN ........................................3 What Is Included ......................................3 Unpacking Instructions ....................................3 Symbols ..........................................3 Disclaimer .......................................... 3 Safety Notes ........................................3 1.5.1 Personal Safety ..........................................3 1.5.2 Mounting and Rigging ........................................3 1.5.3 Power and Wiring ..........................................
Disclaimer The information and specifications contained in this User Manual are subject to change without notice. FROGGYS FOG assumes no responsibility or liability for any errors or omissions and reserves the right to revise or to create this manual at any time.
Description The Titan 1500 PRO features an Over-sized Heater Core to increase run times, Quick Ready Fog Technology (QRFT) has you ready to fog in less than 10 seconds after full cycle and it is ready to fog, and Advanced Low Fluid Sensing shuts down the machine when you run out of fluid to protect the heater core.
On-device Manual Control LCD control board Wireless Control Wired Control Control Protocol DMX512 DMX Channel Range Consumable Consumable Froggys Fog Water Based Fog Fluid Weight & Net Weight 31 lbs Dimensions Gross Weight 36.4 lbs Machine Dimensions 22.7 / 12 /11.5 in Packing Dimensions 27 / 14.4 / 13.6 in...
0 to 100% switch. AC Plug The TITAN 1500 PRO comes with a power input cord terminated with a Lockable Powercon IP65 connector If you need the change the plug, use the table below to wire the new plug: Connection Wire (U.S.)
V1.0 • Make sure the plastic hose entering the TITAN 1500 Pro from the fluid tank cap is not bent or kinked. • Always connect the product to a grounded circuit. Before power on, make sure it is connected with the rated voltage.
Heating Up Preparing Pages The machine is heating up >>>>>>>>>>>>>>> Ready to Fog Standby Page The machine has heated up and ready to fog Titan 1500 Pro Interval 600s Interval output of TIMER mode Titan 1500 Pro Duration 300s Working Pages...
When press ON, the machine will run with the parameter of VOLUME mode accordingly. LCD will display the following page: Fog Output 100% Titan 1500 Pro • All the machines have been paired with the controller included (with certain address code) before leaving the factory.
Maintenance Do not allow the TITAN 1500 Pro to become clogged. After every 40 hours of continuous operation, use distilled water or for a more thorough clean Froggys Fully Clean after use to prevent the accumulation of particulate matter in the heating element.
Need help?
Do you have a question about the TITAN 1500 PRO and is the answer not in the manual?
Questions and answers