3
This Speciality system must be properly installed and located in accordance with the
Installation Instructions before it is used.
Do not
install or store where it will not be
•
exposed to temperatures below freezing or
exposed to any type of weather. Water
freezing in the system will break it. Do not
attempt to treat water over 100°F.
Do not
install in direct sunlight. Excessive
•
sun or heat may cause distortion or other
damage to non-metallic parts.
Properly ground to conform with all gov-
•
erning codes and ordinances.
lead-free solder and flux
Use only
•
sweat-solder connections, as required by
state and federal codes.
Maximum allowable inlet water pressure is
•
125 psi. If daytime pressure is over 80
Proper Installation
psi, night time pressure may exceed the
maximum. Use a pressure reducing valve
to reduce the flow if necessary.
Speciality System resins may degrade in
•
the presence of chlorine above 2 ppm. If
you have chlorine in excess of this
amount, you may experience reduced life
of the resin. In these conditions, you may
wish to consider purchasing a whole house
carbon filter Speciality System system with
for all
a chlorine reducing media.
WARNING:
•
packaging material after installation. Small
parts remaining after the installation could
be a choke hazard.
Discard all unused parts and