General Operation
General operation
Switching on and off and selecting the
function
1 To switch on the set, press POWER
ON/OFF on the system.
2 To select your sound source, press
SOURCE on the front panel of the system
or the respective source buttons on the
remote control: CD,TUNER, MP3 LINK
or USB.
3 To switch off the set, press POWER
ON/OFF on the system.
Adjusting volume and sound
• To adjust the volume, press VOLUME+/- on
the system (or VOL+/- on the remote con-
trol).
• Press DBB on the system or on the remote
control to turn on or off bass enhancement.
• Press MAX SOUND on the system (or
MAX on the remote control) to optimize the
sound output.
• Connect a headphone to the ; jack on the
rear of the system.
•
Press MUTE on the remote control to
temporarily switch off the sound of the system.
Press the same button again to resume.
Digital Tuner
Tuning to radio stations
1 Press SOURCE on the system repeatedly or
press TUNER on the remote control to
select the TUNER (MW or FM) source.
2 Press and hold TUNING +/ - on the system
(or § / ∞ on the remote
display shows SEARCH.
➜ The radio automatically tunes to a station of
sufficient reception.
3 Repeat step 2 if necessary until you find the
desired station.
control) until the
To tune to a weak station, press TUNING
•
+/ - on the system (or § / ∞ on the
remote control) until you have found optimal
reception.
To improve radio reception:
•
For FM, extend, incline and turn the
telescopic aerial. Reduce its length if the signal
is too strong.
•
For MW, the set uses a built-in aerial. Direct
this aerial by turning the whole set.
Programming radio stations
You can store up to a total of 40 radio stations in
the memory, manually or automatically
(Autostore).
Manual programming
1 Tune to your desired station (see Tuning to
radio stations).
2 Press PROG to activate programming.
3 Press ALB -/+ (or ALBUM/PRESET 3/4
on the remote control) once or more to
allocate a number from 1 to 40.
4 Press PROG to confirm.
5 Repeat steps 1-4 to store other stations.
Helpful hints: You can erase a preset station by
storing another frequency in its place.
Autostore
Autostore automatically starts programming radio
stations from preset 1. Any previous presets e.g.
manually programmed will be erased.
1 Select MW or FM.
2 Press and hold PROG until
➜
Available stations are programmed (FM and
MW). After all stations are stored, the first
autostore preset station will then automati-
cally play.
To listen to a preset or autostore station
Press ALB -/+ (or ALBUM/PRESET 3/4 on
the remote control) once or more until the
desired preset station is displayed.
Tuner
displays.