Table of Contents
Advertisement
Power Supply
•
Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to burst:
•
Do not mix battery types: e.g. alkaline with car-
bon zinc. Only use batteries of the same type
for the set.
•
When inserting new batteries, do not try to mix
old batteries with the new ones.
•
Remove the batteries if the set is not to be used
for a long time.
Using AC power
WARNING: Always check you have
completely switched off the set, before
you change or disconnect power supply.
1 Check if the power voltage, as shown on
the type plate located on the
bottom
of the set, corresponds to your
local power supply. If it does not, consult your
dealer or service center.
2
Connect the power cord to the AC
MAINS~ inlet and the wall socket.The set is
now connected and ready for use.
3
To switch the set off completely, withdraw the
power cord from the wall socket.
4
Install the unit near the AC outlet and where
the AC power plug can be easily reached.
•
Disconnect the power cord from the wall
socket to protect your set during heavy
thunderstorms.
The type plate is located on the
bottom
of the set.
Helpful hints:
–
To avoid unnecessary energy consumption,
always adjust the Source selector to TAPE/
OFF after using the set. Also check that the
tape deck keys are released.
General Operation/Tuner
General operation
Switching on and off and selecting the
function
1 To select your sound source, adjust the
Source selector to: CD, TUNER or
TAPE/ OFF.
2 To switch off the set, adjust the Source
selector to TAPE/ OFF position and
check the cassette keys are released.
Adjusting volume and sound
Adjust the sound with the VOLUME and
DBB
controls.
Radio reception
1 Adjust the Source selector to TUNER.
2 Adjust BAND to select your desired
waveband,
MW,
3 Turn TUNING to tune to a station.
Helpful hints:
To improve radio reception
•
For FM, extend, incline and turn the telescop-
ic antenna for best reception. Reduce its
length if the signal is too strong.
•
For
MW,
the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
or FM.
Hide quick links:
Advertisement
Table of Contents
