Lumi NE101 Installation

LADDER FOR
ROYAL ENTRANCE OR WEDDING CAKE STEP
Read carefully the cautions and every steps before assembly and using your step.
Caution : File off all stripped or sharp edges before assembly to avoid injuries and pool damage.
Fig. 1
Left Ramp
Fig. 3
Short Rails
Long Rails
Fig. 5
Fill
Line
Fig. 7
Rev. 2007-11-27
1 -
Platform
left and right ramps using four 2"
bolts, washers and nuts ( g. 1).
2 -
o the self-adhesive pads and center
the pads on the polished areas on
the back of the step ( g. 2).
Right
3 -
Ramp
(short rails on top) and align with the
predrilled holes. Attach sing the eight
2½" (8), bolts, washers and nuts
( g. 3).
4 -
short rails and leave unatached.
Insert the diagonal rails onto the long
and short rails. From the outside of
the step, attach using four 10X¾" (4)
self tapping screws ( g. 4).
5 -
and leave unattached.
6 -
into the fence until it is ¾ full ( g. 5).
7 -
and push it towards the foot of the
step ( g. 6).
8 -
Cap
the pool wall and level it horizontally
( g. 7).
9 -
rests on the toprail. Once at the right
level, attach using the eight 10X¾" (8)
self tapping screws ( g. 8).
Installation
Attach the platform to the
Peel the protective backs
Insert the rails into the step
Slide the ramps over the
Move the step into the water
Pour sand* (approx. 50 lbs.)
Slide the fence into the step
Move the step back against
Adjust the platform until it
Fig. 2
Fig. 4
Fig. 6
Fig. 8
www.lumi-o.com
Diagonal
Rails
p.1