Table of Contents
Advertisement
4.
Secure the red wire labeled BYPASS ENGAGE
SWITCH 2 to the override switch center terminal
number 2
(Figure 22
5.
Secure the gray wire labeled BYPASS ENGAGE
SWITCH 1 to the override switch rear terminal
number 1
(Figure 22
Important:
Incorrect switch wiring can
result in damage to the hydraulic system.
Verify that the wiring is installed correctly;
refer to
Testing the Flow-Divider Manifold
(page
16).
Figure 23
1. Spring-loaded to the rear
of the switch
2. Toggle switch
3. Gray wire
4. Red wire
and
Figure
23).
and
Figure
23).
5. Front terminal
6. Center terminal
7. Rear terminal
6.
Route the toggle switch with the connected
wire harness into the rear of the center console
(Figure
24).
1. Toggle switch
7.
Pull the toggle switch/wire harness through the
center console up to the drilled hole
g273521
1. Rear of center console
8.
Install the toggle switch into the 13 mm (1/2
inch) hole from the bottom of the console; refer
to
Figure 26
washer orientation.
Note:
Install the switch spring-loaded toward
the rear of the machine.
13
Figure 24
2. Rear of center console
Figure 25
2. Toggle switch
for the correct hex locknut and
g035968
(Figure
25).
g212799
Advertisement
Table of Contents
