DeWalt XR LI-ION DCB090 Original Instructions Manual page 53

Your D WALT charger is double insulated in accordance with
E
EN 60335; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially
prepared cord available through the D
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the earth
terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary.
Use an approved extension cable suitable for the power input of your
charger (see Technical Data). The minimum conductor size is 1 mm
the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
OPERATION
Installing and Removing the Battery Pack
(fi g. 1, 2)
NOTE: Make sure your battery pack is fully charged.
IMPORTANT: To avoid battery charge depletion, remove the battery
pack from the DCB090/DCB091 USB charging battery adapter when
not in use.
E NGLI SH
WALT service organisation.
E
2 ;
51