Advertisement
8. Turn the steering fork fully side to side to check for
proper hose flex and position. The hoses should not
rub on the tanks, steering fork, or steering hoses. Note
that the hose clamp brackets are slotted vertically to
allow for adjustment. Secure the hoses in the brackets.
9. Grease all fittings with No. 2 General Purpose Lithium
Based grease.
Installing the Seat Belts
1. Install each end of the seat belt to the holes in the back
of the seat with screws (7/16 x 1 in.) and lock washers
(7/16 in.) (Fig. 7). Tighten them securely. The latch
side of the belt should be mounted to the left side of
the seat.
Note: When operating the machine, always use the seat
belt and ROPS together.
3
Figure 7
1. Seat belt
2. Lynch pin
2. Install the lynch pin into the seat pin to secure the seat
support (Fig. 7).
1
4
2
3. Seat pin
4. Seat support
Installing the ROPS
1. Lower the ROPS frame onto the mounting brackets,
aligning the mounting holes as shown in Figure 8.
Note: To allow installation of the ROPS mounting nut on
the right side of the machine, the double clamp holding
the steering cylinder hoses next to the ROPS support must
be rotated 180_.
2. Secure each side of the roll bar to the mounting
brackets with 2 bolts (5/8 x 4-1/2 in.) and locknuts.
Torque the fasteners to 135–165 ft.-lb. (183–224 N⋅m).
Note: When operating the machine, always use the seat
belt and ROPS together.
Figure 8
1. ROPS
3
1
Advertisement
