Operation - Dimplex DCEVP6 Instruction Manual

Operation

1. Remove the unit from its packaging
2. To begin using the cooling function, open and remove the water tank located at
the back of the unit and fill to the MAX fill line.
3. For extra cooling power, place an ice pack into the water tank.
4. Press the ON/SPEED button to start the appliance.
5. The unit will operate initially on a continual basis. If a set period of operation is
required, please follow TIMER instructions on the previous page.
6. Select the operation MODE as required, by pressing the MODE button.
7. Operate the LEFT / RIGHT & UP / DOWN swing function as required.
8. To switch the unit off at any time, press the OFF button.
Precautions
• Do not overfill the water tank (check the MAX fill line).
• Only fill the water tank half full, when using the ice packs.
• Use only cold, clean filtered water.
• The unit is equipped with a number of safety devices, including a water shortage
protection, tank removal protection & power failure protection.
• Do not allow the same water to sit in the machine for a prolonged period.
• It is recommended that any water left in the machine for 3 days or more be re-
moved and replaced with clean water.
• The control panel must not come in contact with water or any other liquids.
Using the Remote Control
1. Open the battery cover of the remote control, and insert a 3V CR2032 battery.
2. Please point to the receiver when using the remote control.
3. If the battery voltage is low, please open the battery cover as per the diagram
and replace with a new battery (CR2032). Then replace the battery cover.
9