Yamaha HY144-D-SRC Firmware Update Manual page 7

4. If you see the interface selection screen,
select the interface card to connect the
Dante device.
5. Click [Update Dante Firmware].
6. Click [Browse] and select
"FWUpdate_HY144-D-SRC
_mode_vxxx_swyyy.dnt," then click
[Open].
mode represents the SRC mode name,
and yyy represent the firmware version
number.
NOTE
Only alphanumeric characters, "-" (hyphen), and
"_"(underscore) can be used in the path to save the Dante
firmware. If the path contains other characters, Dante
Firmware Update Manager will not work properly. You must
save the Dante firmware in a directory whose name
contains only alphanumeric characters, "-" (hyphen), or "_"
(underscore) (e.g., C:\temp).
NOTE
The SRC modes can be changed by updating to the card's
firmware corresponding to each SRC mode.
 144io mode
FWUpdate_HY144-D-SRC_144io_vxxx_swyyy.dnt
 144io Sync SRC mode
FWUpdate_HY144-D-SRC_144ioSyncSRC_vxxx_swyyy.dnt
 72io Async SRC mode
FWUpdate_HY144-D-SRC_72ioAsyncSRC_vxxx_swyyy.dnt
 144i Async SRC mode
xxx
FWUpdate_HY144-D-SRC_144iAsyncSRC_vxxx_swyyy.dnt
 144o Async SRC mode
FWUpdate_HY144-D-SRC_144oAsyncSRC_vxxx_swyyy.dnt
For details on each of the SRC modes, refer to the "SRC
mode."
7. Click [Next].
NOTE
In some cases the Windows firewall may be blocking the
Dante Firmware Update Manager. Select the [Private
network] check box, and click [Allow access]. Alternatively,
in the Windows firewall, click [Allow programs or functions
through the Windows firewall], and if the "fum" checkbox is
HY144-D-SRC Firmware Update Guide
7