Yamaha HY144-D-SRC Firmware Update Manual page 11

Described below are the procedures to recover
the Dante module integrated in the HY144-D-
SRC.
1. Turn off the power to the device to which
the HY144-D-SRC is installed.
2. Separate the HY144-D-SRC from the
Dante network.
3. Connect the Dante [PRIMARY] connector
of the HY144-D-SRC to the Ethernet
connector on the computer using an
Ethernet cable.
In some cases, an error may occur during
recovery if you are going through a network
switch. Connect the computer with the
HY144-D-SRC in a one-to-one connection.
4. Turn on the power to the device to which
the HY144-D-SRC is installed.
5. Disable all but one of the network
interfaces on your computer.
You should also disable the wireless LAN.
6. Windows: Select [Start]→[All programs]
or [All apps]→[Audinate]→[Dante
Firmware Update Manager]→[Dante
Firmware Update Manager ] , then right-
click and select [Run as Administrator].
Mac: [Application]→[Dante Firmware
Update Manager], then double-click
"Dante Firmware Update Manager."
The Dante Firmware Update Manager will
start up.
NOTE
The "User Account Control" dialog box may appear. Click
[Continue] or [Yes].
HY144-D-SRC Firmware Update Guide
11