Advertisement
4
Installing the Battery
Platform and Wire Harness
Assembly
Parts needed for this procedure:
1
Battery, platform, and wire harness assembly
2
Bolt (5/16 x 1 inch)
1
Spacer (5/16 inch)
4
Nut (5/16 inch)
2
Bolt (5/16 x 2-1/4 inches)
2
Hardened washer (5/16 inch)
Procedure
1.
Align the front of the new battery platform onto
the frame and install the hardware as shown in
Figure
10.
Figure 10
1. Bolt (5/16 x 1 inch)
2. Insert the spacer between
the platform arm and
frame mount.
2.
Install the rear platform assembly mount to the
frame as shown in
3. Nut (5/16 inch)
4. Install the bolt through the
platform arm and frame
mount.
Figure
11.
1. Nut (5/16 inch)
2. Hardened washer (5/16
inch)
3.
Route the wire harness up the left side of the
handle to the underside of the control console.
Note:
Route the wire harness away from any
sharp, hot, or moving parts; secure it with cable
ties as needed.
4.
Connect all of the wire harness connections
as they were connected on the previous
wire harness, except for the T-handle power
connector.
Note:
Some wire harness connections may not
be used depending on the attachments installed
on your machine.
Refer to the labels on the wire harness and
your previously recorded references from
Removing the Existing Battery (page
5.
Secure the wire harness with cable ties and the
cable clips as needed.
6.
Install the battery cover and secure it with the
screws loosened in step
Battery to the Battery Platform (page
g272546
6
Figure 11
3. Bolt (5/16 x 2-1/4 inches)
3).
2
of
3 Installing the
4).
g272547
2
Advertisement
