Sewing On Buttons - Singer M2100 Instruction Manual

Sewing on Buttons

Install the darning plate. (1)
Change the all purpose foot to the button sewing foot. (2)
Position the work under the foot.
Place the button in the desired position and lower the foot.
Set the Pattern Selector Dial for the second zig-zag pattern
(as shown), which should correspond to the distance between
the two holes of the button. Turn the handwheel toward you
to check if the needle goes into the right and left hole of the
button without hitting the button. Slowly sew on the button
with about 10 stitches. (3)
Bring the thread tails to the back of the work, then tie off
manually.
If a shank is required, place a darning needle on top of the
button and sew. (4)
For buttons with 4 holes, sew through the front two holes
first, push the work forward and then sew through the back
two holes.
16