DeWalt DCR020 Original Instructions Manual page 11

DAB Mode – Dynamic Range Compression (DRC)
This function reduces the difference between the loudest
and quietest audio being broadcast. Effectively, this makes
quiet sounds comparatively louder, and loud sounds
comparatively quieter.
The following options are available:
0 broadcast DRC will be ignored
1/2 sets DRC at half the level transmitted
1 uses the DRC level transmitted
2 doubles the DRC level transmitted
nOTE: DRC only works if it is enabled by the broadcaster.
FM Mode – Tuning
To Tune: Push the right arrow to move the tuner up the
frequency band, push the left arrow to move the tuner down
the frequency band.
To seek: Press and hold the right arrow button
release. The tuner frequency will increase to seek the first radio
station with acceptable clarity and stop at that station. The
right arrow button may be pressed again to continue seeking a
radio station at higher frequencies. The left arrow button may
be pressed to seek radio stations at lower frequencies. The Seek
function is available in FM mode.
Programming the Clock
The Time and Date can be updated manually or automatically
synchronised with national time signals broadcast over
DAB (where available).
To synchronise the Clock Automatically:
(DAB mode ONLY)
nOTE: When the radio is first used it will enter DAB mode and
automatically scan for stations.
1. Press the menu button 5 .
2. Use the arrow buttons to scroll to Clock Adjust and press
3
the Enter/Display button 7
3. Scroll to Sync Time Now press the Enter/Display button to
select. This automatically synchronises clock with national
time signals.
To Adjust the Clock Manually:
(FM and DAB mode)
1. Press the menu button .
5
2. Use the arrow buttons 3 to scroll to Clock Adjust on the
LCD display and press the Enter/Display button
3. Scroll to Date & Time and press the Enter/Display button
4. Set the date and time using left and right arrow buttons
5. Once the desired time is set press the Enter/Display
button 7 to commit.
Other Clock Adjust menu options:
• Time format: Select a 12h or 24h time display format
• Date format: Select the date display format, MM/DD/YYYY,
YYYY/MM/DD or DD/MM/YYYY.
once and
3
.
7 .
7
3
Important Radio Notes (Fig. C)
1. The radio will run for up to 14 hours on a fully charged 4.0
amp hour battery in good condition. Using batteries of
lower voltage or capacity will result in less run time.
2. Reception will vary depending on location and strength of
radio signal.
3. Certain generators may cause background noise.
4. To use the auxiliary port
CD or iPod®*/MP3 player into the port. The sound from the
external source plays through the speakers of the radio.
5. The USB power output port
powering low power devices such as mobile phones, CD
and MP3 players. Note that the radio will not charge via the
USB port when powered by batteries. (DCR020 only)
* iPod is a registered trademark of Apple, Inc.
MAINTENANCE
Your D WALT radio has been designed to operate over a long
e
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper care.
Service Notes
This product is not user serviceable. There are no user
serviceable parts inside the radio. Servicing at an authorised
service centre is required to avoid damage to static sensitive
internal components.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this radio could be hazardous.
To reduce the risk of injury, only D
.
accessories should be used with this product.
.
Consult your dealer for further information on the
appropriate accessories.
English
12 , plug the output jack from a
16 is a connection port for
WALT recommended
e
9