Advertisement
5. Once the 200mm pipe is securely fitted to the internal
bracket, connect 150mm ducting to the motor.
Please note, do not use screws to fix the ductwork
to this section as it will prevent the non return valves
from opening during operation. Low grade flexible
ducting should not be used under any circumstances
as it will void the manyfacturer warranty. A minimum
requirement semi rigid duct work can be used. See
approved range of ducting at www.siriusbrand.com
6. Feed the attached ductwork and power cable through
the 200mm section of pipe into the roof cavity. (Fig. 4)
7. Fix the motor to the exposed section of the 200mm
pipe and secure in place with the supplied 8 x 5mm
screws. Please note that the exit point on the motor
needs to be positioned on the low side of the pitch on
the roof. (Fig 5.)
8. Run the motor power cable back to the location of the
rangehood and plug in the connections. There will be
a 6 pin plug and a 2 pin plug as well as an earth wire.
To connect the 2 pin plug, remove the red cap on the
rangehood connection. Remove a screw on the body
of the hood and secure the earth wire to the body,
tighten that screw back into place. The connection for
the 6 pin plug will be exposed and clearly accessible
to plug in. (Fig 6.)
IMPORTANT
Note: Never reduce the ducting diameter under any
circumstances as it will severly effect the performance
and increase noise level of your rangehood. A 150mm
constant diameter duct run is required.
Avoid abrupt changes in direction of your ductwork.
For every 90 degree bend, reduce your maximum
duct length by 1 metre. Example: 2 x 90 degree bend,
maximum duct length should not exceed 5 metres.
9. Run the ductwork from the motor location back to the
location of the rangehood. Connect the ductwork to
the plastic outlet collar on the rangehood and secure
in place. Please note, do not use screws to fix the
ductwork to the rangehood as it will prevent the non
return valves from opening during operation.
10. Plug the rangehood into a 10 amp GPO located within
1 Metre of the rangehood. Press the red reset button
until you feel a click, you will now have power to the
hood and motor and can begin operation of your
Sirius Rangehood.
IMPORTANT
Sirius strongly recommend that the installation of the
SEM5XS316 motor should only be performed by a
suitably qualified tradesperson. Sirius will not be held
responsible for any ongoing issues due to incorrect or
sub standard installation by an unqualified installer.
(Fig. 4)
low side
(Fig. 5)
(Fig. 6)
4
6-pin
earth
plug
wire
dummy
plug
Advertisement
