Advertisement
NOTE
Please be aware for noise reasons the the
SEM5XS316 motor is required to be a minimum
or 2 metres from the location of the rangehood.
3-5 metres is best practice installation.
The motor has a 7 metre long control cable
which cannot be lengthened under any
circumstances. Any attempt to modify this
product in any way will immediately void the
manufacturer warranty.
INSTALLATION
1. Pre determine the exit point where the roof
penetration will be and prepare a hole of 205 mm to
accommodate the motor flue.
2. Fix the Internal Bracket on the inside of the roof
cavity using the 9 x 25mm Screws Supplied in
the packaging. (Fig. 1) Please note that if there is
no timber supports to hold the Internal bracket,
horozontal timber supports (not supplied) may need to
be fitted.
3. Fit the roof flashing to the 200mm diameter steel
pipe (as on Fig. 2) and insert the pipe through the
roof penetration and internal bracket. Sirius Roof
Flashing can be purchased through your retailer or at
Siriusbrand.com. Metal roof flashing code: MRF 6178,
Tiled Roof Flashing code: TRF 6075
4. Fix the 200mm pipe to the internal bracket with the 8 x
supplied 9.5mm screws. Please note that the 200mm
pipe has no pre drilled holes and will need to be drilled
at the desired height by the installer. A minimum of
100mm exposed section of 200mm pipe is required to
accomodate the flashing. (Fig. 3)
(Fig. 1)
(Fig. 2)
(Fig. 3)
8 x 9.5mm long screws
3
Advertisement
