Operating Procedures - Zenith Hydroboil Series Installation And Operating Instructions Manual

Operating Procedures

Tap Operation
Safety feature
Zenith Hydroboil has a unique safety device designed to reduce the incidence of accidental operation of the tap. The
tap can be "Locked" to prevent the Hydroboil from dispensing hot water.
In order to "lock" the tap, ensure the safety button is protruding from the right hand side of the control panel and the
locked indicator is shown.
This can be achieved by pressing the button and simultaneously rotating it until the groove allows the button to pop
out. Once the button is in the extended position, the tap will be "Locked" and unable to dispense hot water (unless the
button is pressed).
Disengage safety feature
Press and simultaneously rotate (aprox 90 degrees) the safety button on the right hand side of the control panel, until it
latches in the closed position, and the unlocked indicator is shown.
Warning:
The unit is now capable of dispensing boiling water without the safety feature.
Locked / unlocked indicators
Continuous operation
Normal operation
Dispensing Boiling water:
Zenith Hydroboil is fitted with a safety, two-way cool-touch safety tap for instant boiling water.
Normal operation (for filling cups and small containers)
To activate the tap, press the safety button on the right side of the control panel and while holding the button in, gently
push the lower end of the tap paddle inwards and boiling water will flow until the tap paddle is released.
Continuous operation (for filling, tea pots, saucepans and large containers )
Press the safety button on the right side of the control panel and while holding the button in, Lift the tap paddle until it
locks into a horizontal position, the button can now be released and boiling water will flow until the paddle is returned
to its normal vertical position. This operation allows a vessel to be filled without holding your hand where it may be
affected by steam.
Page 10 of 24 804546NZ - BW_HB Small_09.18 v1.02