Maintenance - Cosco AC800 Manual

1 The lowest speed
2 The highest speed
3 The highest incline
4 Accelerate time
5 Decelerate time
6 The lowest speed transmission ratio
7 The middle speed transmission ratio
8 The highest speed transmission ratio
◆ Error Message
ERROR CODE
1: ER1: Display board didn't receive signal in 30seconds
2: ER3: over voltage
3: ER4: over current
4: ER5: over load
5: ER6: motor not connect
6: ER7: control board didn't receive signal
7: SAFE: safety protection

MAINTENANCE

Proper maintenance is very important to ensure your treadmill is always in top working condition.
Improper maintenance could cause damage or shorten the life of your treadmill and exceed the
LIMITED WARRANTY coverage.
1. Important: Never use abrasives or solvents to clean the treadmill. To prevent damage to the
computer, keep liquids away and keep it out of direct sunlight.
2. Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately
CLEANING:
Routine cleaning of your treadmill will extend the product's life.
1. Warning: To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is unplugged from
the wall electrical outlet before attempting any cleaning or maintenance.
2. Important: Never use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep liquids
away and keep it out of direct sunlight.
0.1
0.1
0.5
0.2
0.2
0.1
0.1
0.1
- 17 -
0.8
16
无
2.0
2.0
36.0
44.0
46.0