Related Manuals for Fellowes Esi Kata EX2-FF Series
Summary of Contents for Fellowes Esi Kata EX2-FF Series
- Page 1 Kata EX2-FF ™ installation instructions dual fixed+fixed monitor arm Model# KATAEX2-DC-FF-___ Model# KATAEX2-GM-FF-___ ___ = SLV, BLK or WHT...
-
Page 2: Components And Tools
KataEX2-FF Components and tools Caution • Hand tighten screws only. Do not use power tools. Please review these instructions before beginning the installation. Use the illustrations below to check that all the components needed for your installation were provided with your order. Do not discard the packaging until the product works to your satisfaction. Components and tools clamp or grommet mounting: clamp mounting only:... - Page 3 KataEX2-FF Assembly Follow either step #1a for clamp mounting or step #1b for grommet mounting. All other steps apply to both mounting methods. Step #1a: attach base assembly to worksurface — clamp mounting The thickness of the worksurface must be between 0.5" and 2.1". To mount the clamp flush against the worksurface, the thickness must be no more than 1.5".
- Page 4 KataEX2-FF Assembly Step #2: install monitor arms 1. Remove the locking ring from the connection sleeve. Rotate the locking ring counterclockwise to unlock it and then lift it off. 2. Slide the connection sleeve onto the post with the screw toward the rear. With the sleeve at the desired height, tighten the screw using the 4mm Allen key. 3.
- Page 5 KataEX2-FF Assembly Step #4: attach monitors to VESA mounts • Slide each VESA plate (with monitor attached) back onto its VESA mount. — Make sure the VESA plates click securely in place. • OPTIONAL: Secure the VESA plates to the VESA mounts using the M4x15 set screws, as shown below. 2mm Allen key attach set screw...
- Page 6 KataEX2-FF Assembly Step #6: install lockout set screw(s), if desired Default rotation of the fixed arms is 360°. Installation of a lockout set screw limits rotation to 180°. • To lockout fixed arm rotation, install M4x15 set screws. Tighten each screw, then back it off one turn. The screws fit in the underside of the arm stems and fixed arms. —...
- Page 7 KataEX2-FF Assembly Step #8: make any necessary adjustments There are four types of swivel and tilt tension adjustments: 1. Monitor tilt adjustment — Use the 4mm end of the dual Allen key to loosen the screw on the side of the VESA mount to change monitor tilt angle. Tighten the screw to hold the angle. 2.
- Page 8 ESI’s option, of the product or any defective part. Costs (such as installation, labor fees or express shipping) incurred due to replacement of products are not covered under warranty. IN NO EVENT SHALL FELLOWES, ITS AFFILIATES, SUBSIDIARIES, RELATED ENTITIES OR THEIR RESPECTIVE OFFICERS, DIRECTORS, OR EMPLOYEES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, EXEMPLARY, OR SPECIAL DAMAGES.