Related Manuals for ASCOM teleCARE SB
Summary of Contents for ASCOM teleCARE SB
- Page 1 Installation Instructions Pull Cord Switch Module teleCARE M Wall mounting 2005-06-16 / Ver. A Details subject to change without notice TD 92345GB...
- Page 2 Installation Instructions Pull Cord Switch Module teleCARE M Ceiling mounting 2005-06-16 / Ver. A Details subject to change without notice TD 92345GB...
- Page 3 Installation Instructions teleCARE M Pull Cord Switch Module Mounting the backplate When mounting the backplate on an uneven surface, be sure not to bend the backplate. Just use enough pressure to tighten the screws without bending the backplate. Attaching the pull-cord module Step 1: Place the bottom of the switch module over the lower snap fittings of the backplate.
- Page 4 Installation Instructions teleCARE M Pull Cord Switch Module 2005-06-16 / Ver. A Details subject to change without notice TD 92345GB...
- Page 5 Installation Instructions teleCARE M Pull Cord Switch Module Pull Cord Switch Module Programming Solder Pad Settings 2005-06-16 / Ver. A Details subject to change without notice TD 92345GB...
- Page 6 Installation Instructions teleCARE M Pull Cord Switch Module Positioning of the teleCARE Peripherals 2005-06-16 / Ver. A Details subject to change without notice TD 92345GB...
- Page 7 teleCARE Switch Module Dismantling Instructions To remove the face plate of the teleCARE switch modules a screwdriver with a point of approximately 6mm wide is to be used. Insert the point of the screw- driver into the groove at the side of the switch module, between the face plate and the backplate (or surface...
Need help?
Do you have a question about the teleCARE SB and is the answer not in the manual?
Questions and answers