Table of Contents
Advertisement
Troubleshooting
GENERAL
The system does not react when
buttons are pressed.
Sound cannot be heard or is of poor
quality.
The left and right sound outputs are
reversed.
The remote control does not function
properly.
The timer is not working.
Not all buttons are lit.
The Clock/ Timer setting is erased.
34
– Remove the AC power plug for one minute.
Then reconnect and switch on the system again.
– Adjust the volume.
– Disconnect the headphones.
– Check that the speakers are connected correctly.
– Check if the stripped speaker wire is clamped
into the speaker terminal.
– Make sure the MP3-CD was recorded within
32-256 kbps bit rate with sampling frequencies
at 16 kHz, 22,05 kHz, 24 kHz, 32 kHz, 44,1 kHz
or 48 kHz.
– Check the speaker connections and location.
– Select the source (CD or TUNER, for example)
before pressing the function button (É,í,ë).
– Reduce the distance between the remote
control and the system.
– Insert the batteries with their polarities
(+/– signs) aligned as indicated.
– Replace the batteries.
– Point the remote control directly toward the
IR sensor on the front of the system.
– Set the clock correctly.
– Press TIMER ON /OFF to switch on the timer.
– Press DIM to select DIM OFF display mode.
– Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
3139 115 21561
Advertisement
Table of Contents
