Assembly - BRP Evinrude E-TEC Series Service Manual

Hide thumbs Also See for Evinrude E-TEC Series:

Table of Contents

TRIM AND TILT

TRIM AND TILT SERVICE

Slowly remove the manual release valve. There

may be pressure behind the valve—wear safety

Inspect the manual release valve. Discard the O-

rings on the housing.

Remove the four large motor flange retaining

screws. Remove the motor and discard O-ring,

screws, and washers.

Remove drive coupler from either the motor or the

pump assembly.

Assembly

degradable TNT Fluid to fill the hydraulic system.

Install drive coupler in pump assembly.

Install a new motor O-ring.

Use only Evinrude/Johnson Bio-

Table of Contents