Connections; Connecting The Speakers - Philips MCD700/96 User Manual

Speaker
(right)
AC power cord
IMPORTANT!
– The type plate is located at the
bottom of the system.
– The voltage selector located at the
bottom of this system is preset at
220V-240V from the factory. For
countries that operate at 110V-127V,
please adjust to 110V-127V before you
switch on the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched on.

Connecting the speakers

Connect the speakers to the SPEAKERS (8Ω)
terminals with two speaker cables. Right speaker
to "R" and left speaker to "L", red wire to "+"
and silver wire to "-". Fully inser t the stripped
portion of the speaker wire into the terminal as
shown.
MW antenna
FM
antenna
1
1
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the supplied
speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.

Connections

Speaker
(left)
2
For MCD700
2
For MCL707
7