Problem
The DVD player does not start playback.
The DVD player does not respond when
buttons are pressed.
The language for the sound or subtitle
cannot be changed when playing a DVD.
No image is output when a function is
selected.
Sound cannot be heard or is of poor
quality
Poor radio reception.
Troubleshooting
Solution
✔
Insert a readable disc.
✔
Check the disc type, color system and region
code.
✔
Clean the disc.
✔
Place the disc with the playback side down.
✔
Press SYSTEM MENU to turn off the setup
menu.
✔
Cancel the parental control rating function or
change the rating level.
✔
Moisture has condensed inside the system.
Remove the disc and leave the system turned on
for about an hour.
✔
Disconnect the power plug from the jack, and
insert again.
✔
Multi-language sound or subtitle is not recorded
on the DVD.
✔
Changing the language for the sound or subtitle
is prohibited on the DVD.
✔
Make sure the component is connected
correctly.
✔
Press the correct function button for the input
source.
✔
Adjust the volume.
✔
Disconnect the headphones.
✔
Check that the speakers are connected correctly.
✔
Check if the stripped speaker wire is clamped.
✔
If the system is in pause, slow motion or fast
forward/reverse mode, press PLAY/PAUSE 2;
to resume the normal play mode.
✔
Make sure the MP3-CD was recorded within 32-
256 kbps bit rate with sampling frequencies at 48
kHz, 44.1 kHz or 32 kHz.
✔
Ensure that the DTS disc also supports Dolby
Digital output.
✔
If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
✔
Increase the distance between the System and
your TV set or VCR.
39