HUBBELL LIGHTING BEACON ORBEON Installation Instructions

Ceiling mounted led luminaire

ORBEON INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS FOR ORBEON CEILING MOUNTED LED LUMINAIRE

CAUTION HIGH VOLTAGE

LIGHT FIXTURES AND WIRING SHOULD BE SERVICED BY A QUALIFIED ELECTRICIAN

READ THOROUGHLY BEFORE INSTALLING

WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Cole and all local

codes. Failure to do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH.

Install and use so fixture failures do not cause a hazard and use only in environments for which the product is

specifically marked.

WARNING! This product contains chemicals know to the State of California to cause cancer, birth defects, and/

or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this

product.

CAUTION! Follow ALL luminaire and control recommendations, product markings, instructions, restrictions and

warnings regarding luminaire operation and burning position. Luminaire label shows electrical and environmental

requirements and restrictions.

All electrical work must be done by a qualified electrician.

Turn off electric power to all affected circuits and allow to cool before servicing.

Carefully read these instructions before installing product. If you do not understand these instructions, before starting

any work, contact your Hubbell Lighting distributor or techsupport@hubbell-ltg.com or (864) 678-1000.

Give instructions to facility owner/manager for future reference.

Table of Contents

Need help?

Do you have a question about the BEACON ORBEON and is the answer not in the manual?

Page 1 Turn off electric power to all affected circuits and allow to cool before servicing. Carefully read these instructions before installing product. If you do not understand these instructions, before starting any work, contact your Hubbell Lighting distributor or techsupport@hubbell-ltg.com or (864) 678-1000. Give instructions to facility owner/manager for future reference.
Page 2 ORBEON INSTALLATION INSTRUCTIONS page 2 WARNING: TO AVOID DAMAGE TO LED LAMPS, AC POWER SUPPLY MUST BE TURNED OFF BEFORE CONNECTING OR DISCONNECTING SECONDARY WIRING CONNECTIONS. INSTRUCTIONS: (ENSURE THAT POWER IS TURNED OFF) 1. Verify that input power is 120-277 VAC. 2.
Page 3 ORBEON INSTALLATION INSTRUCTIONS page 3 5. Hook the Orbeon housing on to the bracket. 6. Connect the power leads supplied on Orbeon to the power leads in the junction box. 7. Rotate the Orbeon housing upwards to close the fixture. Stuff wiring into junction box.