Table of Contents
Advertisement
Quick Links
Important - Fill Base completely with water before use
Motor Housing
Front
Cover
Light
Switch
Upper
Blade
Guide
Barbed Fitting
Platform
Right Side of Saw
Gryphon Wire Saw Parts Identification
Assembly Step 1
Turn the base of your saw upside down. Push the long piece of tubing from your parts
bag onto the barbed fitting. Tubing inside diameters vary widely from batch to batch and
from manufacturer to manufacturer. Soaking one end of your tubing in hot water helps to
overcome a too-tight fit.
Motor Assembly
Gryphon Diamond Wire Saw model Omni-1
Motor
Switch
Fresh
Water
Fill Spout
Fresh
Water
Reservoir
Fresh
Water
Valve
Used
Water
Valve
Base
Used Water
Drain Barbed Fitting
Assembly Step 2
Place motor assembly on top of base. Slip a plastic washer onto each of the two
plastic thumbscrews found in your parts bag. Insert thumbscrews into blue grom-
mets at the upper outside corners of the water tray. Tighten screws into motor
assembly snug tight only.
Instructions
• Always wear eye protection •
• Do not run blade dry- use plenty of water •
• Keep fingers clear of moving parts •
• Do not operate with finger guard removed •
• Do not operate with front cover removed •
Fresh Water Feed Tube
Left Side of Saw
Upper
Wrist
Pin
Vertical
Connecting
Shafts
Rod
Lower
Wrist
Blade
Pin
Chuck
Aluminum
Block
Insert tube onto barbed fitting
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Gryphon Omin-1
Summary of Contents for Gryphon Omin-1
- Page 1 Instructions Gryphon Diamond Wire Saw model Omni-1 • Always wear eye protection • • Do not run blade dry- use plenty of water • • Keep fingers clear of moving parts • • Do not operate with finger guard removed •...
- Page 2 Assembly Step 3 Push the short piece of tubing from your parts bag onto the barbed fitting at the bottom of your water tray. Thread the other end of the tubing trough the hole just below the blade guide. Take the finger guard from your parts bag and push Motor Insert Assembly...
-
Page 3: Preparing To Saw
When sawing is finished, screw in the water tray screw until water no longer flows onto the blade. ® Gryphon At the end of the day, you can drain the water in the Diamond Wire-Saw made in U.S.A. - Page 4 Warranty Your new Gryphon Diamond Wire Saw is warranted for one year from date of purchase. All mechanical parts with the exception of the blade and blade guides are guaranteed against failure for one year. If such a failure occurs for any reason other than abuse or misuse during this period, it will be repaired (or at our option replaced) free of charge FOB our factory.
Need help?
Do you have a question about the Omin-1 and is the answer not in the manual?
Questions and answers