Advertisement
OPERATING INSTRUCTIONS
1. Check the PDS-21 for any obstructions of the Intake holes
before plugging in the unit or operation of the unit.
2. Set the machine to desired position for operation.
3. Cut tubing to the desired length and attach to the barb fittings.
4. Drill a ½ inch hole in the base of the wall to be dried, and
insert tubing.
5. Plug the power cord into a GFCI outlet.
Do not use an extension cord in conjunction with the Standard
Power Cord
TROUBLESHOOTING
SYMPTOM
PROBLEM
Not plugged in
Switch is worn
Unit will not turn on
Tripped circuit
breaker
Short in power cord
PDS-21 is making
Motor bearing is
strange noises
worn
Motor runs but no
Intake vent is
airflow detected
obstructed
Intake vent is
obstructed
Motor stops running
Motor brushed worn
WARRANTOR:
VIKING EQUIPMENT COMPANY
240 CLARY AVE
SAN GABRIEL, CA 91776
TOLL FREE: (800) 252-5201
WARRANTY AND LIMITATION OF LIABILITY
Viking Equipment Co., Inc. (the "Company") warrants to the first
end-user purchaser that the equipment and parts thereof, when
shipped, will be free from defects in materials and the Company's
workmanship. If any such defects exist or later appear, the Company
shall provide prompt remedial action, as stated herein, to correct
defect. The Company shall have no obligation or liability under this
Warranty unless the customer has obtained a Return Material
Authorization (RMA). To get an RMA you must present proof of
purchase, by the use of the original sales receipt, Internet Product
Registration, or other reasonable and reliable means. To obtain an
RMA, call Viking Equipment Company at (800) 252-5201 and ask for
the Customer Service Department, which will then issue an RMA
number and will arrange for repair or replacement, at our option,
according to the following schedule:
This warranty covers Viking Pressurized Drying Systems (PDS-21).
Year One-100% labor and parts (all components other than those
noted below).
Year Two-Labor only
Year Three through Five-Only materials and workmanship of the
housing are covered.
VIKING Equipment Co.,
SOLUTION
Plug machine in proper
outlet
Replace Switch
Reset Breaker
Replace power cord or
replace cord end
Replace motor
Turn off PDS-21. Remove
obstruction. Restart motor
Remove obstruction. Allow
motor to cool. Motor will
start automatically.
Motor brushes are normal
to cool. Motor will start
automatically.
Toll Free: 1-800-252-5201
Motor Brushes, PVC Hoses, Brass Barb fittings,
gaskets and other wear items are not warranted.
Warranty service shall only be performed by a service
provider authorized by the company.
Freight to Company is the responsibility of the end-
user. The end-user is responsible for normal care and
proper return packaging.
Equipment or Parts there of manufactured by other are
warranted hereunder only to the extent of such
manufacturer's warranty to the Company.
Since after purchase, the Equipment and Parts thereof are under
the sole control of the Purchaser, this warranty is subject to, and
shall be applicable only if, the following conditions are met:
a. The Company's instructions as to usage, operation and
maintenance have been followed;
b. The Equipment and Parts thereof, have been used under
normal indoor operation conditions.
c. The Equipment and Parts thereof have been correctly
operated and maintained and have not been damaged by
misuse, neglect, or accident.
d. The purchaser ha not attempted or performed corrective
work or change on the Equipment and/or parts thereof.
e. The Company should received notice (RMA Requested) of
any defect no later than thirty (30)days after the Purchaser
first had knowledge of the same.
This warranty is in lieu of any and all other warranties,
express, implied or statutory including, without limitation,
warranties of merchantability and fitness for a particular
purpose or use.
LIMITATION OF LIABILITY
THE COMPANY SHALL HAVE NO LIABILITY WHATSOEVER IN
ANY EVENT FOR PAYMENT OF ANY INCIDENTAL OR
CONSEQUINTAIL
DAMAGES,
LIMITATION, WATER DAMAGE (THE END-USER SHOULD
TAKE PRECAUTIONS AGAINST SAME), LOST PROFITS,
DELAY, OR LOSS OF USE, OR DAMAGES FOR INQUIRY TO
ANY
PERSON
OR
PROPERTY.
EQUIPMENT AND/OR
END-USER PRUCHSER OR SUBSEQUENT USWR AGREES
THAT THE COMPANY SHALL NOT BE LIABLE FOR
INDEMNIFICATION OR CONTRIBUTION (IN WHOLE OR IN
PART) EITHER EXPRESSLY OR BY IMPLICATION. IF OR ANY
REASON ANY OF THE FOREGOING PROVSIONS SHALL BE
INEFFECTIVE, THE COMPANY'S LIABILITY FOR DAMAGES
ARISING OUT OF ITS MANUFACTURE OR SALE OF ITS
EQUIPMENT OR PARTS, OR USE THEREOF, WHETHER
SUCH LIABILITY IS BASED ON WARRANTY, CONTRACT,
NEGLIGENCE, STRICT LIABILITY IN TORT OR OTHERWISE
SHALL NOT IN ANY EVENT EXCEED THE FULL PURCHASE
PRICE OF SUCH EQUIPMENT AND PARTS THEREOF.
Any action against the Company based upon any liability or
obligation arising from or under any law applicable to the sale of its
Equipment or Parts, or the use there of, must be commenced within
six months after the cause of such action arises.
a division of
INCLUDING,
BY ACCEPTING THE
PARTS
THEREOF,
THE
www.vikingairmovers.com
WITHOUT
FIRST
Advertisement
