Download Print this page

Viking PDS-21 Owner's Manual

Pressurized drying system

Advertisement

Quick Links

Caution! Read These Instructions Before Operation and Save
Motor Specification
5.7 Inch/145 mm, 2-Stage Tangential By-Pass
120 VAC
106 inches of Vacuum
Over 2600 LPM
1200 Watts
9.3 amps
Double ball bearing construction
UL Recognized, Category PRGY8
GENERAL SAFETY WARNINGS
Never restrict airflow to the inlet. This
Will cause it to overheat and possibly
catch fire.
Ensure that children do not have
access to the equipment. Keep
small children and animals away
from the intake vent. Strong
suction may cause severe injury.
Do not block air output with anything
other than the supplied plug-off system
Do not introduce liquid or flammable materials
into the intake
When using any electrical equipment, basic
precautions should always be followed.
Never operate electrical equipment in
standing water.
VIKING Equipment Co.,
Pressurized Drying System PDS-21
SPECIFICATIONS
• Never service or clean this unit while it is
plugged in.
• Never sit or stand on the unit or use as a
shelf.
• Never intend for outdoor use
• Do not disconnect the unit by pulling on the
cord. Grasp the plug firmly and pull it out of the
wall socket or power receptacle.
• Do not operate the unit with a cut or frayed
power cord.
• To reduce the risk of fire and electric shock, do
not use the air mover with any solid-state
speed control device.
• Always use a grounded outlet.
• Do not use when you are tired, distracted or
under the influence of drugs, alcohol or
medication.
* Do not handle plug with wet hands.
Toll Free: 1-800-252-5201
Owners Manual
Other Specification
Thermal protection in case of overheating due to blocked intake.
PVC (Vinyl) Tubing 3/8 inch ID X ½ inch OD
Hose Barb Adapter 3/8 inch X ¼ MIP
Available at most "Big Box" Hardware Stores
Cautionary Note:
Atmospheric dust and carbon particles from the motor
brushes may emerge through the hoses, leaving a black
residue. Please be advised to plug active unused hoses to
the plug-off system, minimizing leftover residue, which may
discolor light colored carpet.
• Do not leave device plugged when not in use
• Store this equipment indoors; do not expose
to harsh weather.
• Never intend for outdoor use.
• Use only Manufacturer's recommended
attachments.
• Do not pull or carry by the cord, use the cord
as a handle, close doors on the cord, or pull
the cord around sharp edges.
• Do not run over cord.
• Always keep cord and housing away from
heated.
• Always turn the unit off before unplugging.
• Use only as described in this manual.
• Do not place mouth or other body parts Over
the intake holes.
www.vikingairmovers.com

Advertisement

loading

Summary of Contents for Viking PDS-21

  • Page 1 Owners Manual Pressurized Drying System PDS-21 Caution! Read These Instructions Before Operation and Save SPECIFICATIONS Motor Specification Other Specification 5.7 Inch/145 mm, 2-Stage Tangential By-Pass Thermal protection in case of overheating due to blocked intake. PVC (Vinyl) Tubing 3/8 inch ID X ½ inch OD 120 VAC Hose Barb Adapter 3/8 inch X ¼...
  • Page 2: Troubleshooting

    Motor Brushes, PVC Hoses, Brass Barb fittings, gaskets and other wear items are not warranted. 1. Check the PDS-21 for any obstructions of the Intake holes Warranty service shall only be performed by a service before plugging in the unit or operation of the unit.
  • Page 3 Recommendations for using PDS-21 In order to achieve the best air pressure for wall drying, Viking Equipment recommends that the ½ x 3/8 inch Vinyl hoses be cut as shown above. Lengthening hoses will result in a loss of pressure unless pressure is equalized by capping-off one or more hoses to compensate. Hose caps are incorporated into the front of the PDS-21, below the Viking logo.
  • Page 4 Overheating the motor could damage the PDS-21. Caution: Do not block air output with anything other than the supplied plug-off system. This will cause an overpressure condition and may damage PDS-21. VIKING Equipment Co., Toll Free: 1-800-252-5201 www.vikingairmovers.com...
  • Page 5 NOTE* END HOSE THAT IS NOT PLUGGED INTO A WALL HOLE MAY BE PLUGGED BACK INTO THE PLUG-OFF SYSTEM ON THE UNIT INCREASING THE AIR FLOW TO THE OTHER HOSES. a division of VIKING Equipment Co., Toll Free: 1-800-252-5201 www.vikingairmovers.com...