Pc Get-Function Command To Lcd Monitor - BenQ ST430K Series Installation Manual

PC Get-function command to LCD Monitor

Get Function
Model Info
Signal Status
Volume
Mute
Button&IR Control
Video Source
Len Cmd Cmd
Type Code
(Hex
)
20 g 20
8 g 22
8 g 66
8 g 67
8 g 69
8 g 6A
Value Range (ASCII Bytes)
(1) Input value: Byte1 - Byte2 - Byte3...Byte15
Byte2~Byte11=0x00
Byte1=0x01: Get Customer Name
Byte1=0x02: Get Customer Model Name
Byte1=0x04: Get Scaler Firmware Version
Byte1=0x06: Get Serial Number
(2) Return value: Byte1 - Byte2 - Byte3...Byte15
The Byte1 value at the return value should be the same
as the value of Byte1 at input value.
Byte2~Byte15 should be ASCII format.
Ex: If Customer=Generic, Byte1=0x01, Byte2='G',
Byte3='e',...Byte8='c', Byte9~Byte11=0x00.
Ex: If the Scaler Firmware Version=1.02, Byte1=0x03,
Byte2='1', Byte3='.', Byte4='0', Byte5='2',
Byte6~Byte11=0x00.
000: Signal unstable
001: Signal stable (Active Sync exists)
000 ~ 100
000: Off
001: On
000: Disable
001: Enable
000 : VGA
001 : HDMI1
13