Install The Camera - QHYCCD QHYCFW3 Manual

Step 3 Close the top cover
Attach the upper shell to the alignment position and secure the eight holes on the edge of the filter
wheel with eight flat head screws. The filter wheel is installed.
Step 4 Install the camera
1. Fix the camera and filter wheel with M4*10cm and M4*3.5cm hand screws. For symmetry and
beauty, place two M4*10cm thumbscrews under the camera and M4*3.5cm thumbscrews on top of
the camera. The state of the screw is as shown in the figure below.
2. Insert the front end of the camera into the ring of the filter wheel, and then screw the screw in the
position shown above. Make sure you have to tighten and the camera will be fixed.