Table of Contents
Advertisement
INSTALLATION
The OneRemote PowerLink AUX Expander is easily installed:
Connect the AUX Expanders with PowerLink cable(s).
1.
Connect the two sound sources with appropriate cables.
2.
Connect the power supply.
3.
CABLE QUALITY
Be sure to use good quality PowerLink cables, preferably the double-shielded type, especially if
long cables are used. DO NOT use un-shielded cables for any connection.
PowerLink Cable MKII with 4-wire connections is not recommended.
Poorly or non-screened cables pick up noise from the surroundings.
AUX SOURCE NOISE REDUCTION
The AUX input can connect to any controlled line like an output from a
preamplifier or a headphone output from a TV.
Use the NR switch on the OneRemote AUX Expander to match the source and
thereby reduce noise. Use the position giving the best result.
If noise disappears when pulling out the AUX jack, the noise is either being picked up from cables
or the quality of the source is poor.
In rare setups a humming low pitched noise can appear due to problems with ground planes. If
this occurs, an audio transformer can solve the problem.
AUX SOUND LEVEL
Use the two potentiometer adjustments to align the levels of the PowerLink
and AUX sources.
This adjustment also sets the maximum volume for the AUX source.
www.oneremote.dk
Not included.
Not included.
6
Advertisement
Table of Contents
