Step 2: Connecting Speakers; Step 3: Connecting The Control Cable; Step 4: Connecting Tv - Philips MCD716/12 User Manual

Step 2: Connecting speakers

Connect the speaker wires to the SPEAKERS
terminals, right speaker to "R" and left speaker to
"L", coloured (marked) wire to "+" and black
(unmarked) wire to "–". Fully insert the stripped
portion of the speaker wire into the terminal as
shown.
1
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Step 3: Connecting the control
cable
●
Connect the serial port marked "CONTROL
CABLE" at the rear of the DVD player to the
same port at the rear of the power amplifier
with the supplied flat control cable.

Step 4: Connecting TV

IMPORTANT!
– You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.
– A SCART connection allows you to
use features both Audio and Video
features on the DVD Player.
2
Using SCART jack
●
Use the SCART cable (black) to connect the
DVD Player's SCART jack to the corresponding
Scart input jacks on the TV (cable not supplied).
Note:
– Ensure that the "TV" indication on SCART cable
is connected to the TV set and "DVD" indication on
SCART cable is connected to the DVD Player.
Connections
S-VIDEO
IN
AUDIO
TV IN
IN
VIDEO IN
S-VIDEO
AUDIO IN TV IN
IN
VIDEO IN
11