Harman JBL CI55RA Owner's Manual

CI55RA - 2-WAY IN CEILING SPEAKER
Technical Specifications
Tweeter 25mm-Silk Dome
Woofer
5 1/4" Cone Kevlar
Power 100W RMS
Impedance
8 Ohms
Freq. response
70Hz - 20KHz
85dB (@1W/m)
Sensibility
Weight 3.0Kg
11.6"
9.72"
Dimensions for ceiling cutting
Harman Consumer , Inc.
8500 Balboa Boulevard, Northridge, CA 91329 USA
www.jbl.com
© 2017 HARMAN International Industries, Incorporated.
All rights reserved. Harman do Brasil Indústria Eletrônica e Participações Ltda. is a trademark of Harman International Industries,
registered in the United States and/or other countries. Features, specifications and appearance are subject to change without notice.
1. TAKE DE GRILL OUT SO THAT THE
MOUNTING SCREWS ARE EXPOSED
Remove the grill first, insert the iron
speaker into the grill and then pull
up or pushed up the mounting legs
carefully until the edge of grill come
up.
2. CONFIRM THE INSTALLATION
LOCATION SIZE
Remove the inner square anti-paint
board from the supplied square tem
-plate and keep it well for later use.
Use the inner ring part of square anti
-paint board to mark the size and
position of the mounting hole.
Make sure that the mounting legs
are inward spin. Put the speaker
into the excavated empty hole.
3. CONNECTION
Connect the positive terminal of
the amplifier output signal to the
red terminal of the crossover and
the negative terminal to the black
terminal.
4. ANGLE ADJUSTMENT
Use a Phillips screwdriver to loosen the
left and right 2 screws (shown above)
inside the inner frame, and then push
the middle puller (shown bellow) to
adjust the angle.
Remark: the angle can be adjusted
between 15 to 45 degrees.
5. FIXED THE SPEAKER
After adjusting the angle to the proper
position, tighten the left and right scre
-ws with a Phillips screwdriver to ensure
that it does not slide. Use a wrench to
externally rotate the mounting legs
and fix the speaker to the wall or ceiling.
Make sure that the mounting legs are
fixed on the wall or on the ceiling. Be
careful not to tighten the screws over
and then cover the grill.
mounting
legs
6. DISASSEMBLE THE SPEAKER
Remove the speakers from the
wall or the ceiling, loosen the
screws enough to remove the
speaker.Be careful to prevent the
loss of the mounting legs.
Cód.: 030142 - Rev.: 00 - 07/17