Transmitter Controls - Horizon Fitness HRZ00001 Manual

EN
7
6
5
3
ASSEMBLING AND DISASSEMBLING TRANSMITTER HANDLE
Assemble
1. On the top transmitter portion, press the rear button.
2. Slide the transmitter handle into the track.
Disassemble
1. On the top transmitter portion, press the rear button.
2. Slide the transmitter handle out of the track.
The transmitter allows you to adjust steering and throttle dual rates.
Steering Dual Rate
1. Power ON the transmitter.
2. Power ON the model.
3. Apply either the left or right steering input on the transmitter and
hold that position.
4. To add or remove steering throw input, hold the steering input
button and press the (+) or (–) ST DR button.
Binding is the process of programming the receiver to recognize the GUID
(Globally Unique Identifi er) code of a single specifi c transmitter.
1. Verify the receiver and transmitter are OFF.
2. Connect a fully charged battery to the receiver.
3. Power ON the transmitter.
1. Power ON the transmitter.
2. Press the bind button on the receiver using a small pin and power on the receiver.
The LED will flash then turn solid when Failsafe is set.
3. Remove the bind plug.
2

TRANSMITTER CONTROLS

8 9
4
1
2
ADJUSTING THE DUAL RATES
1. Steering Wheel Controls direction (left/right) of the model
2. Throttle Trigger Controls speed and direction (forward/brake/reverse) of the model
3. ON/OFF Switch Turns the power ON/OFF
4. TH DR/TH Trim Adjusts the throttle trim/end points
5. ST DR/ST Trim Adjusts the steering trim/end points
6. CH 3
7. Indicator Lights
• Solid blue light—Indicates radio connectivity and adequate battery power
• Flashing blue light—Indicates the battery voltage is critically low. Replace
batteries
8. REV Reverses the steering wheel and throttle functions
9. Antenna Transmits the signal to the model
Throttle Dual Rate
1. Turn ON transmitter.
2. Turn ON the model.
3. Apply either forward or reverse throttle input on the transmitter
and hold that position.
4. To add or remove throttle input, hold the steering input button
and press the (+) or (–) ST DR button.
NOTICE: Adjusting the throttle input will negatively affect the self
righting feature as it relies on the motor RPM.
NOTICE: Do not adjust the throttle dual rate while the model is
powered on and resting on a stand. Adjusting the throttle dual rate
may power the motor, which could cause damage to property or
personal injury.
BINDING
4. Press the bind button on the receiver using a small pin and power on
the receiver. The LED will flash when binding is in progress.
5. The LED turns solid when binding in successful.
NOTICE: Do not attempt to bind the transmitter and receiver if there
You must rebind when binding the receiver to a different transmitter.
are other compatible transmitters in bind mode within 400 feet. Doing
so may result in unexpected binding.
FAILSAFE
HRZ00001