Beper Juice'N Go BP.600 Use Instructions page 8

Personal Blender Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
DESCRIPTION OF PARTS (Fig. 1)
A Power base
B Motor housing
C BPA-free jar
D Drink-through lid
E Blade set
This appliance has been designed for HOME USE ONLY and must not be used for commercial and indu-
strial purposes.
INSTRUCTIONS FOR USE
IMPORTANT NOTE:
Before using the appliance, we recommend washing all removable parts that will come into contact with food.
Use hot water, a cloth and a mild detergent. Dry thoroughly.
- Place the BPA-free jar (C) on a flat, horizontal surface with the opening facing upwards and pour in the ingre-
dients, already cut into small pieces if necessary, without exceeding the "550 ML" level marked on the jar itself.
- Place the blade set (E) on the open end of the jar (C) and turn it clockwise until it locks completely in place
(Fig. 2).
- Turn the jar (C) upside down and place it onto the power base (A) making sure that it fits properly. (Fig. 3).
- Plug the appliance.
- Pressing gently the jar (C) and turn it clockwise to start the blender. (Fig. 4)
- To stop the blender, turn the jar (C) anti-clockwise.
- After use, unplug the appliance and wait for the blade set to stop completely before removing the jar (C) from
the power base (A).
- Turn the jar (C) upright and place it on a flat surface.
To open the jar (C), unscrew the blade set (E).
8