Table of Contents
Advertisement
4 Get started
Caution
•
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
rear of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from
heat, sunshine or fi re. Never discard batteries
in fi re.
3
1
2
1
Open the battery compartment.
2
Insert 2 AAA batteries (not supplied)
with correct polarity (+/-) as indicated.
3
Close the battery compartment.
12
EN
Note
•
If you are not going to use the remote control
for a long time, remove the batteries.
•
Do not use old and new or different types of
batteries in combination.
•
Batteries contain chemical substances, so they
should be disposed of properly.
Auto install radio stations
When you connect the unit to the power
supply for the fi rst time, or no radio station is
stored in this unit, Plug and Play is activated to
store all available radio stations automatically.
1
Connect the unit to the power supply.
»
[AUTO INSTALL - PLEASE PRESS
PLAY, STOP CANCEL] (auto install
- press
; to cancel, press
displayed.
2
Press
on the main unit to start
installation.
»
[AUTO] (auto) is displayed.
»
The unit automatically stores radio
stations with suffi cient signal strength.
»
When all the available radio stations
are stored, the fi rst preset radio station
is broadcast automatically.
Turn on
1
Press POWER.
»
The unit switches to the last selected
source.
Switch to standby
1
Press POWER to switch the unit to
standby mode.
»
The backlight on the display panel is
reduced.
»
The clock (if set) appears on the
display panel.
) is
Advertisement
Table of Contents
