Table of Contents
Advertisement
Supported MP3 disc formats
ISO9660, Joliet
Maximum title number: 999 (depending
Maximum album number: 99
Supported sampling frequencies: 32 kHz,
44.1 kHz, 48 kHz
Supported Bit-rates: 32-320 (kbps),
variable bit rates
ID3 tag v2.0 to v2.3
Directory nesting up to a maximum of
8 levels
Maintenance
Clean the cabinet
Use a soft cloth slightly moistened with
a mild detergent solution. Do not use
a solution containing alcohol, spirits,
ammonia or abrasives.
Clean discs
When a disc becomes dirty,
clean it with a cleaning
cloth. Wipe the disc from
the centre out.
Do not use solvents
such as benzene, thinner,
commercially available
cleaners, or antistatic spray intended for
analogue records.
Clean the disc lens
After prolonged use, dirt or dust may
accumulate at the disc lens. To ensure
good play quality, clean the disc lens
with Philips CD lens cleaner or any
commercially available cleaner. Follow the
instructions supplied with cleaner.
18
EN
9 Troubleshooting
Warning
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site
(www.philips.com/welcome). When you
contact Philips, ensure that the apparatus
is nearby and the model number and serial
number are available.
No power
Ensure that the AC power plug of the
unit is connected properly.
Ensure that there is power at the AC
outlet.
To save power, the unit switches to Eco
Standby mode automatically after
15 minutes in standby mode.
No sound
Adjust the volume.
No response from the unit
Disconnect and reconnect the AC power
plug, then turn on the unit again.
No disc detected
Insert a disc.
Check if the disc is inserted with the print
side facing inward.
Wait until the moisture condensation at
the lens has cleared.
Replace or clean the disc.
Remote control does not work
select the correct source with the remote
control instead of the main unit.
Reduce the distance between the remote
control and the unit.
Advertisement
Table of Contents
