Get Started; Connect Speakers - Philips DCM713/93 User Manual

3 Get started

Caution
•
Use of controls or adjustments or
performance of procedures other than herein
may result in hazardous radiation exposure or
other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________

Connect speakers

Note
•
Ensure that the colors of the speaker wires and
terminals are matched.
•
For optimal sound, use the supplied speakers
only.
•
Connect only speakers with impedance that is
the same or higher than the supplied speakers.
Refer to the SpeciÀ cations section of this
manual.
For the main unit side:
1
Unscrew the speaker connectors.
2
Insert fully the red end of a speaker cable
into the left red (+) connector.
3
Screw the left red (+) connector to
secure the cable.
4
Insert fully the silver end of a speaker
cable into the left black (-) connector.
5
Screw the left black (-) connector to
secure the cable.
6
Repeat steps 2-5 to insert the other
speaker cable into the right connectors.
a b
For the speaker side:
1
Unscrew the speaker connectors.
2
For the left speaker, identify the speaker
cable that is connected to the left
connectors on the main unit.
3
Insert fully the red end of the speaker
cable into the red (+) connector.
4
Screw the red (+) connector to secure
the cable.
5
Insert fully the silver end of the speaker
cable into the black (-) connector.
6
Screw the black (-) connector to secure
the cable.
7
Repeat steps 2-6 for the right speaker.
c
EN 9