Storage - HLA BR72 Operator's Manual

Snow
Fast brush speeds and slow travel speeds are needed to sweep snow effectively. Start as ¾ throttle and the lowest gear of
the power unit. For wet and/or deep snow, increase to almost full throttle. This helps to keep snow from packing up inside
the brush hood.
In deep snow you may need to make multiple passes to get down to a clean surface.
To keep snow from blowing back in to the swept area, always sweep so the wind is at your back or so it follows the brush
angle.
Dirt & Gravel
To keep dust at a minimum, plan sweeping for days when it is overcast and humid or after it has rained. Also, sweep so
the wind blows at your back or in the direction the brush head is angled.
Low brush speeds and moderate travel speeds work best for cleaning debris from hard surfaces. Brush speeds that are
too fast tend to raise dust because of the aggressive brush action.
To sweep gravel, use just enough brush speed to "roll" the gravel, not throw it.
Heavy Debris
Travel slowly – less then 5mph (8kph).
Sweep a path less that the full width of the Broom.
Increase engine speed if debris becomes very heavy.
The following storage procedure will assist you to keep your Broom in top condition.
NOTICE DO NOT STORE BROOM WITH WEIGHT ON THE BRUSH.
destroying the sweeping effectiveness. To avoid this problem, place the Broom on blocks or optional
stands.
The polypropylene bristles will deteriorate in sun, high heat or flame. Do not store in direct sunlight for
any extended period of time.

STORAGE:

1. Clean Broom thoroughly; removing all mud, dirt and grease.
2. Inspect for visible signs of wear, breakage or damage. Order any parts required and make necessary repairs, to avoid delays
when starting next season.
3. Tighten all loose nuts, cap screws and hydraulic connections.
4. Lubricate grease fittings.
5. Connect hydraulic couplers together, or install covers, to protect hydraulic system from contaminates.
6. Retouch all unpainted and exposed areas with paint to prevent rust.
7. Replace decals, if damaged or are illegible.
8. Store Broom in a dry, protected place, with a cover, if possible. Leaving attachment outside will materially shorten its life.
REMOVING FROM STORAGE:
1. Remove all protective coverings.
2. Check hydraulic hoses for deterioration and replace if necessary.
BROOM OPERATION (cont.)
BROOM STORAGE
- 10 -
Weight will deform the bristles,