Table of Contents
Advertisement
Before You Begin
Before handling the product, read the instructions and safety guidelines on the
following pages to prevent damage to the product and to ensure your own personal
safety. Refer to the "Advisories" section in the Preface for advisory conventions used
in this user's guide, including the distinction between Warnings, Cautions, Important
Notes, and Notes.
Always use caution when handling/operating a computer. Only qualified,
experienced, authorized electronics service personnel should access the
interior of a computer. The power supplies produce high voltages and
energy hazards, which can cause bodily harm.
Use extreme caution when installing or removing components. Refer to the
installation instructions in this user's guide for precautions and procedures.
If you have any questions, please contact Quanmax Post-Sales Technical
Support.
High voltages are present inside the chassis when the unit's power cord is
plugged into an electrical outlet. Turn off system power, turn off the power
supply, and then disconnect the power cord from its source before
removing the chassis cover. Turning off the system power switch does not
remove power to components.
When Working Inside a Computer
Before taking covers off a computer, perform the following steps:
1.
Turn off the computer and any peripherals.
2.
Disconnect the computer and peripherals from their power sources or
subsystems to prevent electric shock or system board damage. This does not
apply when hot swapping parts.
QDS-8200 User's Manual
Safety Instructions
WARNING
6
Safety Instructions
Advertisement
Table of Contents
