Night Owl Smart Safe NCS-03WFB Quick Setup Manual page 5

QSG-NCS04WF.pdf
3
A
Press and hold the "Reset Access Code" button inside of the safe for 5 seconds to set
the Digital Access Code.
beeps twice.
Note: You have 30 seconds to program the code. The safe beeps three times and the "Setup" LED turns solid blue
for 3 seconds after entering a new 4-digit code.
A
C
C
M
Y
CM
MY
CY
CMY
K
4
Close the safe and enter your 4-Digit Access Code (you will hear a beep for every key
pressed.) Once you enter the correct 4-Digit Access Code, the safe will open. If you enter
an incorrect 4-Digit Access Code, the safe will not open without the use of the Safe Key.
Note: After entering the wrong password 5 times, the safe locks the keypad for 1 hour.
5 12/10/18 8:00 PM
B
The "Setup" LED on the safe then turns blue, blinks rapidly, and
C
While the LED is blinking, enter a 4-digit access code.
B
Warning
Setup
Error
Warning
Setup
Error
Warning
Setup
Error
BEEP
BEEP
BEEP
4