Advertisement
Quick Links
Silicone Rubber Heating Blankets
SRL, SRP, SRMU, SRX, & Custom Series
Instruction Manual
Read and understand this manual before operating or
servicing this heater. Failure to understand how to
safely operate these heaters could result in an
accident causing serious injury or death. Only
qualified personnel should operate or service heater.
Advertisement
Related Manuals for BriskHeat SRL Series
Summary of Contents for BriskHeat SRL Series
- Page 1 Silicone Rubber Heating Blankets SRL, SRP, SRMU, SRX, & Custom Series Instruction Manual Read and understand this manual before operating or servicing this heater. Failure to understand how to safely operate these heaters could result in an accident causing serious injury or death. Only qualified personnel should operate or service heater.
-
Page 2: Table Of Contents
Troubleshooting Guide ..............7 Warranty Information ..............8 INTRODUCTION ® Thank you for purchasing a BriskHeat Silicone Rubber Heating Blanket. Your heater is designed to provide a long and efficient service life with function, reliability, and safety in mind. For additional ®... -
Page 3: Important Safety Instructions
SRX heaters. use. Failure to observe these warnings may result in Failure to observe these warnings may result in personal injury or damage to the heater. personal injury or damage to the heater. ® BriskHeat Corporation. All rights reserved... -
Page 4: Prior To Installation
The heater is designed to work at a specific voltage to heat properly. For additional information, contact your local ® distributor or BriskHeat Confirm blanket maximum exposure temperature rating is suitable for environment. The temperature of the internal heating element may run up to 25% higher than the external surface of the blanket. -
Page 5: Mounting Your Heating Blanket
Use a medium to hard roller to eliminate trapped pockets of air. Do not wrap the heater over itself or allow it to contact a second heater. ® BriskHeat Corporation. All rights reserved... -
Page 6: Connecting Heating Blanket To A Power Source
The blanket may require a temporary method of attachment to secure the ® heater until the PSA cures. Use a high-temperature adhesive tape (BriskHeat Part # AAT2180) to secure the heater. For larger heaters, press the heater onto the surface as the film is removed. -
Page 7: Troubleshooting Guide
Power lead wires should be connected to the power source (or temperature control device) directly, through a junction box, or to a connector that is ® mated to a receptacle connected to the power source. BriskHeat Heating Blankets are non-polarized, allowing either power lead wire to be connected to the neutral or hot. -
Page 8: Warranty Information
® determined by BriskHeat to be defective. The complete details of the warranty can be found online at www.briskheat.com/t-warranty.aspx or by contacting us at 1-800-848-7673 (toll free, U.S. / Canada) or 1-614-294-3376 (Worldwide). 1055 Gibbard Ave, Columbus, OH 43201 Toll Free: 800-848-7673...