Download Print this page

Setup And Use - Summit Razor SS Instructions Manual

2009 climbing treestands

Advertisement

4c
OPENSHOT / RAZOR SHARED ASSEMBLY
RAPIDCLIMB STIRRUPS
1. Position the stirrup as shown in figure 17. The curved
end of the stirrup should face down and in - toward the
center of the platform.
2. Once positioned secure with the supplied bolt and wing
nut as shown in
figure 18. Occasional readjustment might be necessary
as your footwear needs change. To adjust, simply loosen
the wing nut and slide the stirrup up or down. It is not
necessary to completely remove the nut to adjust the
stirrup.
3. Wrap the supplied bungee cord around one side of the
curved platform upright bars and push the S-hook through
the loop as shown in figure 19. The bungee should always
be attached ABOVE the stirrup on the tree side of the
upright bars.
4. Pull the hook across the platform and loop it over the
opposite upright bar. Hook it back over it self as shown in
figure 20.
BACKPACK STRAPS
1. Wrap the buckle end of the 2" wide strap around the
second rung on the platform as shown in figure 21. Push
the 3 Bar Slide through the buckle as shown in
figure 22. The buckle should look like figure 23 when
complete. Pulling on the straps should cinch down the
buckle.
2. Place the looped end of the 1" wide strap around the
platform tubing at point A and bring the loose end back
through the loop as shown in figure 24. Pull tight to create
a cinch knot. Repeat for the other side.
3. Thread the loose end of each 1" strap through the
buckle on the 2" strap as shown in figure 25.
2" WIDE
STRAP
(PN 40274)
5

SETUP AND USE

Read and understand the harness usage
instructions before attempting to climb! Be sure
to maintain full body safety harness attachment to
the tree at all times after leaving the ground.
PG 6
23
WARNING
!
17
STIRRUP
19
TOWARDS
TREE
21
24
1" WIDE STRAP
(PN 30283)
A
ATTACHMENT TO THE TREE
1. Attach the base platform to the tree first. To do
this, pull down and hold the QuickDraw cable spring
as shown in figure 26. This will release the locking
tab from the cable, allowing the cable to be pushed
past the locking tab.
18
20
22
25
www.summitstands.com

Advertisement

loading

This manual is also suitable for:

Openshot deluxe