Get Started; Prepare The Remote Control; Set Clock; Turn On - Philips DCB188/05 User Manual

4 Get started

Caution
•
Use the controls only as stated in this user
manual.
•
Always follow the instructions in this chapter
in sequence.
If you contact Philips, you will be asked for the
model and serial number of your apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from
heat, sunshine or fire. Never discard batteries
in fire.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert 2 AAA batteries (not supplied)
with correct polarity (+/-) as indicated.
3
Close the battery compartment.
3
1
2
Note
• If you are not going to use the remote control
for a long time, remove the batteries.
•
Do not use old and new or different types of
batteries in combination.
•
Batteries contain chemical substances, so they
should be disposed of properly.

Set clock

1
In the standby mode, press and hold
CLOCK/DISPLAY to activate the clock
setting mode.
»
The 12 hour or 24 hour format is
displayed.
2
Press PROG repeatedly to select 12 hour
or 24 hour format.
3
Press CLOCK/DISPLAY to confirm.
»
The hour digits are displayed and begin
to blink.
4
Press / to set the hour.
5
Press CLOCK/DISPLAY to confirm.
»
The minute digits are displayed and
begin to blink.
6
Press / to set the minute.
7
Press CLOCK/DISPLAY to confirm.

Turn on

1
Press POWER.
»
The product switches to the last
selected source.
Switch to standby
1
Press POWER to switch the unit to
standby mode.
»
The clock (if set) appears on the
display panel.
EN 13