SILYNX C4OPS Fast Manual page 2

SETTING UP
GETTING STARTED
C4OPS In Ear Headset
Basic In Ear Headset
(Blocked Connector)
(1)
Connect
Headband
Boom Mic
C4OPS Control Box
*
(2)
Primary Radio Lead
(6) (3)
Secondary
Connect Connect
Radio Lead
Intercom Cable Adaptor
Peltor/ Sordin
Maritime Headset Config
Headset Adaptor
*1.5V AA Lithium battery
NOTE: No battery needed if using MBITR side connector.
C4OPS CONTROLS
Rotary Knob
Off/ On/ Volume Level
Primary PTT
Secondary PTT
OPERATING C4OPS
Hybrid Headset
(Boom Mic Connector)
Ops Core Chinstrap
Boom Mic
(5)
Tighten
Shell Ear Retainers
(4)
Attach
Attach collar clip.
Headset on your ear.
Press ear bud
until foam ear
plug expands.
PTT3 / Hot Key
(1) Turn MBITR on. (2) Turn C4OPS on.
(+)
Enable MBITR side
connector.
Mode
(-)
OR
No = Pass
®
MOUNTING THE CONTROL BOX
Zipties
Molle Clip
INSERTING EAR BUDS
Keep mic exposed
Hang In Ear Squash foam Pull upper ear up and
back and push the ear
ear plug.
bud firmly into the canal.
Tighten nape slider. Position ear
retainer.
EAR BUD LEAK TEST
(3) MBITR is auto set (4) Ear plug sealing
test will begin.
to external audio and
keypad locked.
VP "C4OPS 2X Beep"
(5)
"Leak "Leak
Right" Left"
VP
Leak = Reinsert ear plugs /
replace ear plug size.
"Leak Both"
BASIC FUNCTIONS
PAIRING DUAL WIRELESS PTT [DWPTT]
(+) Hear Thru
High Sensitivity
(1) Press
& hold
Zipties (-) Hear Thru
Low Sensitivity/
Hear Thru Off
"Pairing Activated"
Beeps 30 sec
NOTE: If "Pairing Failed" repeat the steps above.
HEAR THRU LEVEL
High Sensitivity
Low Sensitivity/
Hear Thru Off
NOTE: In windy conditions
reduce "Hear Thru"
CHANNEL SELECTION
(2) Press & hold 3 sec
to confirm
(1) Press until you hear
"Channel Selection"
(2) Press & hold 3 sec
to confirm
EXTRAS
Press & hold 3 sec
(2) Press & hold
pairing keys 3 sec
(+) Volume
(-) Volume
Secondary PTT
Primary PTT
"Pairing Successful"
VOLUME LEVEL
Off/ On/ Volume Level
VOICE PROMPT VOLUME LEVEL
(2) (+) Volume
(1) Press until
you hear "Voice
Prompt Level"
(2) (-) Volume
TROUBLESHOOTING:
In high noise, such as aircraft/vehicles,
you may hear whistling. Press (-) until
the sound disappears. If the problem
continues, reinsert the ear buds and
make sure you pass the sealing test.
"Extras"
= Important
= Voice Prompt
VP