Table of Contents
Advertisement
Preparations
OR
for the devices with USB cables:
1
Insert one plug of the USB cable (not supplied)
to the
socket on the set.
2
Insert the other plug of the USB cable to the
USB output terminal of the USB device.
OR
for the memory card:
●
Fully insert the memory card (metal contact
facing left) into the SD / MMC slot on the top
of the system.
Connecting other equipment to your
system
This feature allows you to listen to music from
the external equipment throught the powrful
speakers of the Hi-Fi system.
●
Use an Aux-in cable (supplied) to connect the
AUX IN-1 or AUX-2 jack (3.5mm, located on
the bottom panel) to an AUDIO OUT or
headphone jack on an external device (such as
TV, Laser Disc player, DVD player or CD
recorder).
Note:
– Refer to the operating instructions for the
connected equipment for details.
Mounting the set onto wall
See the separate sheet of Wall mounting
instructions on how to mount the set onto wall.
Note:
– To secure the mounting on wall, cement wall is
required.
10
Using Remote Control
IMPORTANT!
– Before using the remote control,
remove the insulation plastic tab as
shown in the picture below.
– If the remote control does not
function correctly or the operating range
is reduced, replace the battery with a
new (CR2025) battery.
1
Push to open the battery tray.
2
Replace a new battery according to the
indicated polarity.
3
Push the battery tray back to close it.
Using the Remote Control to operate
the Player
1
Aim the Remote Control directly at the remote
sensor (IR) on the front panel.
2
Select the source you wish to control by
pressing one of the source select buttons on the
remote.
3
Then select the desired function (for example,
ÉÅ, ¡ or ™).
CAUTION!
– Remove battery if it is exhausted or will
not be used for a long time.
– Battery contains chemical substances, so
they should be disposed of properly.
– Perchlorate Material-special handling
may apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
Hide quick links:
Advertisement
Table of Contents
