For All Of Vehicles; General Notice - Lexus IS300 2005 Manual

Hide thumbs Also See for IS300 2005:
Table of Contents

Advertisement

IN-10
2005 LEXUS IS300 (RM1140U)
INTRODUCTION

FOR ALL OF VEHICLES

PRECAUTION
1.
(a)
(b)
Negative Cable
BO4111
-
FOR ALL OF VEHICLES
FOR VEHICLES EQUIPPED WITH SRS AIRBAG AND
SEAT BELT PRETENSIONER
The LEXUS IS300 is equipped with an Supplemental Re-
straint System (SRS), such as the driver airbag, front pas-
senger airbag assembly, side airbag assembly, curtain
shield airbag assembly and seat belt pretensioners.
Failure to carry out service operations in the correct se-
quence could cause the supplemental restraint system to
unexpectedly deploy during servicing, possibly leading to
a serious accident.
Further, if a mistake is made in servicing the supplemental
restraint system, it is possible the SRS may fail to operate
when required. Before servicing (including removal or
installation of parts, inspection or replacement), be sure
to read the following items carefully, then follow the cor-
rect procedure described in this manual.

GENERAL NOTICE

(1)
Malfunction symptoms of the SRS are difficult to
confirm, so the diagnostic trouble codes become
the most important source of information when trou-
bleshooting. When troubleshooting the supplemen-
tal restraint system, always check the diagnostic
trouble codes before disconnecting the battery (see
page
DI-607
).
(2)
Work must be started after 90 seconds from the
time the ignition switch is turned to the LOCK posi-
tion and the negative (-) terminal cable is discon-
nected from the battery.
(The supplemental restraint system is equipped
with a back-up power source so that if work is
started within 90 seconds of disconnecting the neg-
ative (-) terminal cable from the battery, the SRS
may deploy.)
When the negative (-) terminal cable is discon-
nected from the battery, memory of the clock and
audio systems will be cancelled. So before starting
work, make a record of the contents memorized by
the each memory system. Then when work is fin-
ished, reset the clock and audio systems as before.
To avoid erasing the memory of each memory sys-
tem, never use a back-up power supply from anoth-
er battery.
Author :
IN0KE-01
Date :
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents